Encoder angle speed displacement pulse counter
  • Model: WJ66
  • In Stock: 999999

Encoder angle speed displacement pulse counter

$53.84
Part No.:  WJ66-485    WJ66-232Product features:            >>Encoder decoding to standard MODBUS RTU protocol>>It can be used as encoder counter or speed measurement , it supports simultaneous counting of 4 encoders, and can identify positive and reverse directions        ...

Add to Cart:
  • Shipping Weight: 100lbs
  • This product was added to our catalog on Saturday 04 April, 2020.
Description
Part No.:  WJ66-485    WJ66-232
Product features:            
>>Encoder decoding to standard MODBUS RTU protocol
>>It can be used as encoder counter or speed measurement , it supports simultaneous counting of 4 encoders, and can identify positive and reverse directions           
>>Built in 8 DOS can be used as encoder upper and lower limit alarm output           
>>Automatically save counter data in case of power failure          
>>Each circuit of built-in do can output PWM signal independently       
>>Reset and set the count value through RS-485 / 232 interface          
>>Wide power supply range: 8 ~ 32vdc            
High reliability, convenient programming and easy application           
>>Standard din35 guide rail installation, convenient for centralized wiring          
>>User programmable module address, baud rate, etc           
>>Low cost, small volume modular design           
>>Overall dimension: 120 mm x 70 mm x 43 mm            
Typical applications:           
>>Encoder pulse signal measurement            
>>Displacement or angle measurement            
>>Motor speed measurement and control            
>>Control multiple devices instead of meter counter          
>>Remote transmission of encoder signal to industrial computer       
>>Intelligent factory and industrial Internet of things            
>>Direct data transmission to control center instead of PLC            

Product overview:            
    WJ66 product realizes signal acquisition between sensor and host, which is used to decode encoder signal and equipment control. WJ66 series products can be used in RS-232 / 485 bus industrial automation control system, automatic machine tools, industrial robots, three coordinate positioning system, displacement measurement, stroke measurement, angle measurement, speed measurement, etc.            
Products include signal isolation, pulse signal capture, signal conversion and RS-485 serial communication. Each serial port can be connected with 255 WJ66 series modules at most. The communication mode adopts ASCII code communication protocol or MODBUS RTU communication protocol. The baud rate can be set by code. It can be hung on the same RS-485 bus with the control modules of other manufacturers, which is convenient for computer programming.            
   WJ66 series products are intelligent monitoring and control system based on single chip microcomputer. All configuration information such as address, baud rate, data format, verification and status set by users are stored in EEPROM.            
Wj66 series products are designed and manufactured according to industrial standards, with no isolation between signal input and output, strong anti-interference ability and high reliability. Operating temperature range - 45~ + 85 deg.C.     
Reviews (0)
There are currently no product reviews.
Back to Top